Inventions Needed 03 23 2013
1.
A C-Clamp
that has one end of the turning pin weighted so that one can use one hand to
spin the gap loose or tight to the approximate size of what is to be clamped.
2.
A Consumer Coffee Grinder that can grind a whole
bag of coffee at one time.
3.
How much light or lumen's could be created by
putting a coiled fiber optic geometric shape on the end of a laser or LED
light? If you had a fiber optic coil the
width of your ceiling with a reflective surface behind it attached to and led
or laser how many lumen's of output could you create?
Could a modular piece of Plexiglas or
acrylic glass be designed with a fiber optic void channel inside such that one
watt of electricity to a laser or LED could produce 5000 lumen's of light or
more? And what of a fiber optic strand
that had one half the cross section coated with a reflective surface? Such a light based on that technology would
not need a separate reflector!
4.
A clear tube to go on the end of a rifle. This would allow one to know if mud or water
had gotten inside the end of the barrel.
Water in the barrel can lead to the barrel exploding when the gun is
fired. The clear tube of a larger
diameter on the end of the barrel would also prevent water or brush from
getting in the end of the barrel. I
cannot say what percent of gun accidents it would prevent from happening other
than to say some.
5.
Car grounding straps should be mandatory.
Copyright 03 23 2013 Thomas Paul
Murphy
Originally published on 03 23 2013
at: www.themilwaukeeandwisconsinnews.blogspot.com
No comments:
Post a Comment